Enable optical module interface

The set interface optics-monitor enable command enables or disables optical module monitoring and alerting for all switch interfaces. You can check monitoring information of optical modules in the run show interface diagnostics optics command result and in the log file. This chapter describes how to configure the Optical Amplifier Module and Protection Switching Module (PSM). When you plan to replace a configured optical module with a different type of optical module, you must clear the configurations of the old module before you install the new module. For. Specifies the management interface, core and advance management features, and memory map. It is supported by a set of supplements (IA's) for specific applications. Coherent-CMIS: Provides extensions to CMIS to manage modules with coherent interfaces. CMIS-Form Factor: Provides details of HW pins. When the optical module on an interface is faulty, you can run the display commands to view information about the optical module. Related Information Video Identify a Huawei-Certified Optical Module Run the display transceiver [ interface interface-type interface-number | slot slot-id ] [ verbose ]. By default, Cisco switches perform authenticity validation on inserted optical modules. If a module is identified as non-Cisco original, the switch may shut down the port, trigger an alarm, or display a warning message. For information about which F5 ® transceiver modules support DDM, see F5® Platforms: Accessories. [PDF]